Find or Sell Used Cars, Trucks, and SUVs in USA

1955 Chevrolet Belair 2dr Hardtop Rolling Chassis Project Car No Engine Or Trans on 2040-cars

US $4,500.00
Year:1955 Mileage:100000
Location:

Greenback, Tennessee, United States

Greenback, Tennessee, United States

rust in rockers. has had some pans installed great solid frame trim and glass included many parts. was v8 powerglide car

Auto Services in Tennessee

Wurster`s Foreign Car Repair ★★★★★

Auto Repair & Service, Automobile Diagnostic Service, Automobile Inspection Stations & Services
Address: Defeated
Phone: (615) 208-5654

Wheel Tek ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Tire Dealers
Address: 5434 Pleasant View Rd, Memphis
Phone: (901) 606-6988

Wheel Tek ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Tire Dealers
Address: 5434 Pleasant View Rd, Millington
Phone: (901) 606-6988

Wheel 1 ★★★★★

Automobile Parts & Supplies, Wheels, Automobile Accessories
Address: 816 Space Park N, Joelton
Phone: (615) 851-7217

West End Tire Sales Inc ★★★★★

Auto Repair & Service, Tire Dealers
Address: 501 W Lamar Alexander Pkwy, Louisville
Phone: (865) 982-7836

Tullahoma Tire & Brake Inc ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Tire Dealers
Address: 400 N Jackson St, Decherd
Phone: (931) 455-1024

Auto blog

GM recalls select Chevy Cruze, Sonic and Buick Verano models over airbag issue

Wed, 14 Nov 2012

General Motors is recalling certain 2012 Buick Verano, Chevrolet Cruze and Sonic models due to a defect in the driver's airbag system. According to the National Highway Traffic Safety Administration, the airbag has a shorting bar which may contact two internal terminals. If that happens during a crash, the supplemental restraint may not deploy, increasing the risk of driver injury. The recall includes a total of 2,949 units.
GM will contact owners and replace the steering wheel airbag coil at no cost. At this point, it's unclear when the recall will begin, though owners may contact the automaker at 1-800-521-7300 for more information. You may also take a closer look at the full NHTSA notice below.

Chevy might've pulled out of NASCAR if it weren't for new Gen 6 car

Wed, 20 Feb 2013

We've been on the fence with NASCAR for some time now. On one hand, it's some of the closest racing anywhere in motorsports, with actual passing and door-handle-to-door-handle action as a matter of course. But on the other, it's become template racing - a personality-driven sport more about the drivers than any sort of loyalty to a particular automaker. The Car Of Tomorrow format really rammed that message home, with a racecar's identity coming down to little more than headlamp stickers slapped on the nose. That's not necessarily a bad thing in and of itself, but we've wondered for some time what's in it for the automakers, who pay big money to stay in a series that has had little increasingly little do with street car sales, let alone innovation.
Apparently General Motors was beginning to wonder the same thing. In a new ESPN report, Rick Hendrick, team owner of Hendrick Motorsports, suggests that GM would have seriously considered leaving NASCAR if it wasn't for the move away from the COT to the new Gen 6 racer. According to Hendrick, GM North America boss Mark Reuss spearheaded the charge away from the 2007 COT and toward a racecar with clearer automaker ties - cars like the new Chevrolet SS racer shown above. Learn more about the fight for a closer-to-production look in the ESPN story at the link.
Now, if we could just get more rear-wheel drive V8 coupes into showrooms....

Experimental mid-engine XP-819 Corvette going up for auction

Sun, 17 Feb 2013

It seems to be commonplace that when a new Corvette is in development, rumors swirl about a possible mid-engine layout. As is the case of Chevy's most recent C7 Corvette, these rumors never pan out.
In any case, the idea for a 'Vette with an engine mounted behind the driver can probably all be traced back to a single car, the 1964 XP-819 prototype. Built as an "engineering exercise" back in 1964, the prototype was designed with a rear-mounted engine. History tells us that the idea of a rear-engine Corvette fizzled, and the XP-819 was eventually cut up into pieces and stored at a shop in Daytona Beach, FL.
After sitting for untold years, a restoration project started on the car, and while it isn't yet fully completed, the current owner of the car, Mid America Motorworks, will have the car on display at the 2013 Amelia Island Concours d'Elegance as a "driveable chassis" with hopes of having a fully completed car ready to bring to next year's show.