1984 Chevy S-10 Blazer- Custom on 2040-cars

VIN: 1G8CS18B1E8218843 Year: 1984
Number of Cylinders: 8
Make: Chevrolet
Model: Blazer
Warranty: Vehicle does NOT have an existing warranty
Trim: 2DR
Options: CD Player
Drive Type: AUTOMATIC
Power Options: Air Conditioning, Cruise Control, Power Locks, Power Windows
Mileage: 999,999
Sub Model: S-10
Exterior Color: Black
Number of Doors: 2
Interior Color: BLACK/GREY

Condition: Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ... 

1984 Chevy S10 Blazer, 383 stroker motor with super light race crank, Lunati roller rockers, speed pro roller lifters , melling oil pump, TCI harmonic balancer, special turbo 400 transmission with less than a thousand miles on it ( this transmission has a switch pitch converter- push the button on the B&M ratchet shifter and it goes from 2000 rpm stall to a 4500 stall making it great for street or strip ) Mallory breakerless distributor, Mallory pro coil, Griffin aluminum radiator with electric fan, drive shaft loop, Floating rear axle - ford nine inch rear axle, I think it has a 410 Richmond gear set, four wheel disc brakes, B&M ratchet shifter, chrome headers ( these were wrapped to reduce engine heat) with flowmaster mufflers and 2 1/2 inch exhaust, cyberdyne gauges, edelbrock victor jr. aluminum 4-barrel intake, custom paint, Alpine six disc stereo, rear mounted holly comp 140 electric fuel pump and filter, weld wheels all around,  the boost gauge on the A-piller is not connected as this was for a paxton supercharger that was removed , it has 2 extra cragar wheels with tires, the lower graphics resemble granite, and has battery box is mounted in the rear, the front has been lowered 2 inches via aftermarket kit.... now for the bad .. I removed the hood and fenders to install a fiberglass flip front end, and while I was working seven days a week I had to put this project on hold.. when I got back to it someone had taken the carburetor. The engine has about four hundred miles on it , but has been setting for a few years . I removed the heads and there was a wasp nest in two of the cylinders, I cleaned them out and it is turning over just fine but I think a cylinder hone should be used to clean any surface rust or imperfections. The heads are supposed to be Dart II world product heads. but not sure,  I have an untried carburetor that I will give to the buyer but you will need a new battery. The mileage is listed as 999,999 because all of the gauges are electronic the actual mileage is closer to about forty thousand miles. The body and the interior are in very good condition, power brakes, power windows .. the paint will need some minor attention as the clear coat is flaking, there are two small dents that I have seen, one in the hood and one on the roof by the passenger door and one rust spot noticed in the lower rear quarter where it was sitting in the weeds. The windshield has a small starburst that is barely noticeable and all of the other glass is perfect, the window tint is failing on the rear glass but should be no problem to replace or remove. I have this listed locally so I reserve the right to end this auction early,  No I don't want to sell the Stroker motor, transmission, or any other parts separately at this time thanks. This is an as is where is sale so please ask any and all questions before bidding and I will try to answer them asap. I want happy buyers not Bad feed back.. Please remember the heads were removed to clear the wasp nests and have not been put back on , so bring cash and a trailer .. .