91 Chevy 4x4 With Lift, White Exterior, Ext Cab, With Edelbrock Carb, Fosgate on 2040-cars

Auto blog

2014 Chevrolet Cruze TD fires up its new diesel motor

Ever since General Motors confirmed plans to produce a diesel-powered Cruze back in 2011, we've been eagerly awaiting its arrival. And as part of the 2013 Chicago Auto Show, Chevrolet has pulled back the cover on its oil-burning compact sedan, set to go on sale in the near future with a starting price of $25,695, not including $810 for destination.
The heart and soul of the Cruze TD (that's its official name) is a 2.0-liter turbo-diesel inline four-cylinder engine rated at 148 horsepower and 258 pound-feet of torque, mated solely to a six-speed automatic transmission. The engine also has an overboost function that will increase torque to 280 lb-ft for up to ten seconds. The full brace of official specs haven't been released, but GM tells us that highway fuel economy will come in at 42 miles per gallon. If that number sounds familiar, it's because the Volkswagen Jetta TDI has the exact same rating. Unlike the Jetta, however, the Cruze TD can run on B20 biodiesel, where as the Volkswagen can only accept B5.
Model-specific changes to this 2014 Cruze TD include an aero kit and unique 17-inch alloy wheels. Inside, there's a full leather interior, and Chevrolet will provide two years of complimentary scheduled maintenance, not to mention a 100,000-mile powertrain warranty.

Final C6 Corvette built in Bowling Green

With all of the attention given to the 2014 Chevrolet Corvette Stingray lately, you could be forgiven for thinking that it's already well along in production, yet tooling up for the new C7 has only just begun. In fact, production of the outgoing C6 generation in Bowling Green, Kentucky just halted on Thursday.
As the C6 has aged, production numbers have predictably ebbed along with demand, but this year, the addition of the 427 and 60th anniversary models resulted in an uptick in vehicles built - this, despite a model year shortened by around 25 percent to accomodate the new model changeover. The final C6 Corvette ever, No. 13,466 built this year, was a white 427 Convertible destined for the General Motors Heritage Center museum. The car's 7.0-liter V8 heart was assembled by Corvette chief engineer Tadge Juechter himself.
In total, Bowling Green pushed out 215,100 C6 Corvettes over nine years. If you're still a C6 fan at heart and are hoping to get a good deal on a phase-out model, step lively - Chevrolet reportedly had about 6,100 unsold units, which Autoweek suggests is good for around five and a half months of supply at the model's current sales rates. Given that demand will likely slacken even further as the C7 draws closer, that should be a big enough stockpile to keep dealers satisfied until 2014 Stingrays begin showing up on their forecourts in December.

More Corvette Stingray Factoids: Vanishing panel gaps and 26-mpg LT1

During January's Detroit Auto Show, we managed a longer than expected wandering tag-team interview with C7 Corvette chief engineering exec Tadge Juechter (pictured above), and LT1 engine boss Jordan Lee (pictured below). They are, quite honestly, two of the very nicest bigshot lads to ever walk the engineering corridors of an American manufacturer. Both are enthralled by what they're doing for a day job. So are we.
We've followed the pre-sale anticipation for the Chevrolet C7 Corvette Stingray like an Oreck vacuum yanking every speck of dirt from a well-trampled carpet. Everything is reportable and contains a grain of further knowledge about this dramatically important and cheered-for car, as it continues to be pressured into representing all that is superior about the American dream. The Corvette wears one heavy cloak.
So, most of what was talked about has been expertly reported already right here on Autoblog. But, looking through our notes again, both Jeuchter and Lee added facts to the buzzing mix.