1988 Chevy K30 Cummins 12valve Turbo Diesel 4x4 Conversion No Reserve on 2040-cars
Wilmington, Delaware, United States
Body Type:Pickup Truck
Vehicle Title:Clear
Engine:Cummins diesel
Fuel Type:Diesel
For Sale By:Private Seller
Make: Chevrolet
Model: C/K Pickup 3500
Cab Type (For Trucks Only): Crew Cab
Trim: Base
Options: 4-Wheel Drive, CD Player
Drive Type: Automatic and 4x4
Power Options: Air Conditioning, Power Locks, Power Windows
Mileage: 45,000
Exterior Color: Red
Interior Color: Tan
Warranty: Vehicle does NOT have an existing warranty
Number of Cylinders: 6
Thanks for looking, please read the description completely and carefully. It should answer most questions.
1988 Chevy Crew Cab 4x4 K/V30 heavy duty 1 ton with a 1st gen. Cummins turbo diesel. I bought the truck with a blown 454 and put in a low mileage drivetrain from a '92 Dodge truck. The Dodge title (which I have) and odometer read 29K. As for the body and chassis, I don't know exactly how many miles it had but would figure about 200k. Since the conversion i have put about 10-15k on it. I drove the truck for several years after putting it together and it ran very well. The truck has been parked for a few years, during which time the rocker panels and cab corners were replaced. I have painted those areas of the truck but it could use a complete paint job if you want a super nice looking vehicle. The clear coat over the red is rough in some places. It has a very solid body but does have some dents and dings. There is light surface rust in a few areas on the frame and the body. Take a look at the pictures and it should give you an idea of the rust. I raised the body 3 inches to clear the engine and installed new body mounts at that time. The floor pans are solid, however the inside portion where the rocker attaches to has rusted through in a couple places. I sand blasted and repainted all the metal behind the rocker panels and cab corners. This truck was originally sold as a cab and chassis setup, bed was added by previous owner.
Ok, now for the engine, this is a rotary injection pump (has been resealed and had larger fuel pin and 3200 rpm gov. spring installed). There are 2 sets of injectors that come with the truck, factory and a set of 100+hp injectors. The turbo is a later model HX 35 which spools quickly. Boost can hit 30 lbs. The Dodge intercooler and radiator where used. The engine runs smoothly and does not seem to use oil. I fabricated the exhaust from 4 inch pipe starting right behind the turbo. I used the factory Dodge crossmembers for the engine and trans, so mounting points are Dodge design. The truck smokes a little at idle with the big injectors but still gets about 18-20 mpg highway at about 65. I believe rpms are about 2000 at 65.
The trans is the Dodge A518 automatic overdrive. Before it was installed in the truck, I rebuilt the trans with performance parts and a special low stall convertor from DTT. This trans does not have lockup. The convertor holds the power very well and the trans shifts and works well.
The transfer case is the Dodge version of the NP205 cast iron case gear drive. The driveshafts were cut and rebalanced and u joints were replaced at the time of swap. The axles are the original Chevy setup with a Dana 60 solid front axle and an open 14 bolt corporate rear. The ratios are matched at 3.73 and run well on the highway. I currently run 285/75/16 tires. Front will need replaced and rear have about 50%. (BFG all terrain T/A)
The A/C was converted to r134a and uses a Dodge compressor made for that refrigerant. Both the A/C & heating systems work well.
The interior is basic with no headliner or surrounding trim. It does have power locks and windows which work on 3 of the doors. Radio is a newer cd player and I put new speakers on the door panels and new 6*9 speakers behind rear seats. From the pictures, you will see a few cracks in the dash and there are some small holes from probably a cb or other controls. The driver seat area is rough but all other areas are good. It has tilt steering and intermitent wipers. The carpet is a charcoal grey and is not the original design. I have recently installed new door gaskets on all 4 doors. The truck can be a little noisy inside since there is no headliner or extra trim. I do have some Dynamat material that goes with the truck, I just never installed it. Also, the guages are Autometer and Sunpro and are set into the factory dash panel. There is a boost guage, trans temp guage and also a egt guage that have the sensors installed, but need to be hooked up. The truck was originally set up with dual fuel tanks and I retained that system. However, the aftermarket fuel guage calibration is slightly off so it stays on full for quite a while, then drops quickly. (I did run out of fuel a couple times before learning this.) Truck recently drove about 300 miles with no trouble at all. Email me through ebay if you have any questions.
Chevrolet C/K Pickup 3500 for Sale
- 1986 chevrolet 1 ton 4x4
- 1997 chevrolet k3500 cheyenne 4x4 crew cab pickup 4-door 6.5l turbo diesel
- 1988 chevy ambulance / zombie hunting vehicle(US $3,500.00)
- 1989 chevrolet 3500 black beauty low miles
- 1986 chevy silverado 1 ton dually custom car hauler truck show truck!
- 1984 chevy military pu diesel 1 ton 4x4 dana 60 front end low mileage(US $4,000.00)
Auto Services in Delaware
Star Loan Auto Ctr ★★★★★
Springfield Mitsubishi Pa ★★★★★
Rick`s Auto Service ★★★★★
Pro-Bond Auto Glass ★★★★★
Piazza Honda of Drexel Hill ★★★★★
Oxford Auto & Tire ★★★★★
Auto blog
Supercharged 2015 Chevy Corvette Z06 takes the C7 beyond the ZR1
Mon, 13 Jan 2014
The Z06 is just about everything we got in the last ZR1, but better.
After a bright-yellow false start, here is the real thing: the fourth-generation, 2015 Corvette Z06. If Chevrolet makes a ZR1 version of the C7 Corvette, it's going to be absolutely mega, because the Z06 is just about everything we got in the last ZR1, but better.
Chevy Corvette Stingray "colorizer" lets you chase the rainbow
Thu, 14 Feb 2013After you've convinced your better half to let you buy a new Corvette, then comes the hard part... actually figuring out which 'Vette you want. While Chevrolet has yet to release the official configurator for the 2014 Corvette Stingray, it did give us something else to kill some time playing around with.
The C7 Corvette "colorizer" recently went online, and it lets you look at the car in all of its available colors and wheel options from four different angles so that when this car does go on sale, you know exactly which one you want. It includes the Corvette's full pallet of colors including Torch Red, Laguna Blue and the hue you see above, Velocity Yellow. Toss in the black wheels, and we're sold. If you have some time this afternoon, be sure to check it out the Corvette colorizer for yourself, and even if you don't have the time, we've put together a gallery with all of the possible color combinations.
Subprime financing on the rise in new car sales, leasing too
Fri, 07 Dec 2012We all remember the financial crisis that began several years back. At its core was a splurge of subprime lending for housing loans. The housing bubble burst, triggering a collapse of the mortgage-backed securities market. Apparently, those types of loans still exist in the automotive industry, and the market share for these types of "nonprime, subprime, and deep subprime," loans has grown 13.6 percent compared to the third quarter a year ago.
According to an Automotive News report, high-risk lending expanded to 24.8 percent of total loans in Q3, up from 21.9 percent for this time last year. As this level increased, average credit scores of borrowers dropped to 755, down from 763 a year ago. In that time, the average financing amount increased $90 per vehicle, to $25,963.
At 818, Volvo maintains the highest per-owner credit score, while Mitsubishi has the lowest, at 694. The highest rate of borrowers was at Toyota, with 14 percent of the market, followed by Ford with 13.1 percent and Chevrolet at 11.1.