Rat Rod--bagged--shop Truck 1966 Chevy C10 Stepside V8 350 on 2040-cars

1966 Chevy c10 Rat Rod CLEAR TITLE ?Air ride - all 4 corners, FBSS, 8 valve, dual compressor, 1/2 line, 2-5gal tanks ?Chevy 350 all new parts - New gaskets, seals, alternator, water pump, starter, wires, plugs, distr, and headers. Before install was told engine was rebuilt, has small cam, took top and bottom off, heads, rockers bearings, all looked new, no metal shavings, burn marks, or cracked pieces. Headers are flanged and piped, no exhaust ?Edelbrock Intake and 4 barrel carb ?3 speed with custom high handle shifter, new clutch and flywheel ?Suicide doors on AUTOLOCK remote pop ?New copper fuel lines with aluminum fuel tank ?59 Caddy tail lights ?Custom made door panels and visor ?12 volt easy wire kit with fuse block ?Dual batteries ?Lower A-Arms have been modified (removed inside cupping then metal re-enforced) allows air bag to sit flat, no chance for it to rub, and drops truck lower. ?New ball Joints ?Rear has small notch - Air bags mounted on rear trailing arms ?Composite deck boards for bed floor ?Flat black paint - bodywork and paint needs finishing ?New windshield - all other glass fine ?Bench seat, dash painted ?15" wide white radials ?Needs speedometer and windshield wiper motor ?Only rust is cab corners - have new ones on order ?Comes with complete front disc brake suspension - crossmember, A-arms, steering rods, links. Easy swap bolts straight up. If your a good welder fitter you can cut / pancake this crossmember which will allow truck to lay frame without cutting / Z'ing frame. ?No a/c or heat - heater box under hood as well as control box under dash. No hoses ran to them never hooked up to see if it works. ?MY LOSS SOMEONES GAIN - ALOT MORE $$$ VESTED THEN ASKING PRICE