2014 Chrysler Town & Country Touring on 2040-cars

Auto blog

2015 Chrysler 200 caught looking good after leaking out

We can't yet share all the details on the 2015 Chrysler 200 sedan, but we can direct your attention to the image above, which was published by the boys at Jalopnik after Chrysler reportedly let it out by accident. As you can see, the new 200 will be a nicely styled piece of machinery.
According to leaked documentation, the 2015 Chrysler 200 will come with the buyer's choice of a 2.4-liter Tiger Shark four-cylinder engine with 184 horsepower and 173 pound-feet of torque or a 3.6-liter Pentastar V6 boasting 295 horses and 262 lb-ft. Those ponies will be routed through a nine-speed automatic with a rotary gear selector, sending power to the front wheels. Alternatively, a high-tech all-wheel-drive system will be available that can electronically disconnect the rear axle, saving fuel.
Speaking of fuel efficiency, the 2015 200 will be able to achieve up to 35 miles per gallon on the highway, which is an impressive figure for this class. An on-sale date has yet to be announced, but the next 200 will start at $21,700 (plus $995 for destination) when it does finally hit dealerships.

Chrysler recalls small number of 2013-2014 cars and trucks over engine debris

Chrysler is recalling a small number cars over issues with their 2.4-liter four-cylinder engines. The recall, which affects 522 examples of its 2013 Dodge Avenger and Chrysler 200 models, as well as 2014 Jeep Compass and Patriot CUVs has to do with potential debris in the balance shaft bearings.
The abrasive stuff can cause the oil pressure to drop, which could lead to the engine stalling or outright failure. This situation could at best leave drivers stranded and at worst lead to a crash.
Chrysler will begin notifying owners, who will need to report in to have the balance shaft module replaced. All repairs are naturally free of charge. Scroll down for the bulletin from NHTSA.

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.