1973 Dodge Dart Swinger 3.7l on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

2014 Challenger R/T Shaker, Mopar '14 Challenger bring back iconic hood

Enamored of the Dodge Challenger but wish you could get one with a shaker hood? We've got good news, because Dodge and Mopar have teamed up to bring it back.
The 2014 Dodge Challenger R/T Shaker packs the same 5.7-liter Hemi V8 as the standard Challenger R/T, but upgrades the business end with a through-the-hood exposed cold-air intake system. The retro hood scoop protrudes from the center of the hood in satin black (matching the decklid spoiler) to feed the Hemi and shakes with the engine just like the original from 1970. The Shaker model also comes with a Super Track Pak that adds a new steering rack, brake linings, shocks and 20-inch Goodyear Eagle F1 Super Car rubber. You can also shut off the stability management system completely in this car. A series of interior and exterior trim enhancements round out the look. The whole package adds $2,500 to the price of a Challenger R/T Classic for an all-in MSRP of $36,995.
In case that's not enough, Dodge is also offering a limited-edition Mopar Challenger that follows the 2010 Mopar Challenger, 2011 Mopar Charger, 2012 Mopar 300 and 2013 Mopar Dart. Limited to just 100 examples, the 2014 Mopar Challenger gets the same Shaker hood intake, unique graphics and wheels, an enhanced interior and a long list of optional extras from the Mopar parts catalog. Dodge isn't saying just yet how much the Mopar Challenger will cost, but you can bet it will command a considerable premium for the exclusivity alone.

Dodge celebrates centennial with Charger and Challenger 100th Anniversary Editions

In 1914, the Dodge brothers went from being a parts supplier to a full-scale automaker, and to celebrate the centennial of this milestone, Dodge will offer special editions of the 2014 Charger and Challenger early next year. Both cars will be sold in limited numbers (although no specific number was given), and these cars will stand out thanks to unique touches like 20-inch wheels, 100th anniversary edition logos and the exclusive High Octane Red Pearl Coat paint job (shown above).
The 100th Anniversary Edition package, which runs $2,200 on the 2014 Charger and $2,500 on the 2014 Challenger, comes with red or black leather seats with a cloud print (for a denim-like look) and metal badges on the seatbacks that read "Dodge Est. 1914," while similar logos are also found on the wheel center caps and front fenders. The instrument gauges are unique to each car, with the Charger getting black gauges and the Challenger getting white gauges, and to enunciate the 100-year anniversary, both cars have red numerals on the speedometer for the 100-mile-per-hour mark.
Finishing off the 100th Anniversary Edition cars, which will be offered on V6 and R/T models, Dodge adds a flat-bottom steering wheel and embroidered floor mats as a part of the package. Scroll down for the full press release for these commemorative models.