1994 Dodge Viper Base Convertible 2-door 8.0l on 2040-cars

Auto blog

Chrysler investing $20M in Toledo plant to support 9-speed auto production

In 2011, Chrysler announced a $72-million investment in its Toledo Machining Plant to modernize production of the eight- and nine-speed torque-converters for automatic transmissions made there. That upgrade work won't be finished until Q3 of this year, but Chrysler has already announced a further $19.6-million investment to increase production capacity for the nine-speeders.
The extra units will be necessary because the nine-speed transmission they'll be mated to is going into three popular models: it will debut on the 2014 Jeep Cherokee, then go into the Chrysler 200 and Dodge Dart. The company predicted that this year alone it would sell 200,000 units equipped with the nine-speed tranny, and it is spending some $374 million in addition to the investment in Toledo to upgrade production capacity for it.
The work attached to this new investment won't begin until Q3 of 2014, and it will be finished by the end of that year. There's a press release below with all the details.

NHTSA investigating 110,000 Ram 2500s and 3500s, one death alleged

The National Highway Traffic Safety Administration has launched an investigation focusing on 110,000 Dodge Ram 2500 and 3500 pickups from model years 2004 to 2006. One death has already been reported, according to NHTSA, due to a potential fault with the clutch interlocks on manual-transmission versions of the heavy duty pickup.
According to the report, these trucks can be started without depressing the clutch. There have been three reports so far, and as we mentioned above, one very sad incident seems to have resulted in the death of a child.
"One complaint involved an incident that occurred when a child was able to enter the vehicle and start the ignition without depressing the clutch. The vehicle then moved forward striking another child resulting in a fatality," NHTSA said in the investigation bulletin, which you can view below.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.