1969 Ford Bronco 4 X 4 Rebuilt 351 Svo Roller Motor Aod Trans on 2040-cars

Auto blog

Tanner Foust gets eponymous hotted-up Ford Focus ST from Cobb Tuning

Racer and Top Gear USA host Tanner Foust has partnered up with Cobb Tuning to create a special-edition Ford Focus ST. The limited-edition hatches will come packing a reflashed ECU, special intercooler, tweaked intake and freer-flowing exhaust for up to 20 percent more power than the stock creation. Cobb says that the changes should push the final dyno figure to above 300 horsepower. Buyers can also expect to find special carbon fiber aerodynamic bits on board along with a new grille, graphics and wheels. Cobb hasn't released pricing on this Tanner Foust Edition Ford Focus ST as of yet, but you can bet the whole kit won't be cheap.
Fortunately, the company will sell you bits and pieces from the overall package for your Ford, and word has it engineers are also whipping up a Foust Fiesta ST. Look for Cobb's Focus ST website to go live next month, complete with accurate specs and pricing. Until then, enjoy clicking through the gallery here. You can also check out the full press release below.

2015 Ford Mustang EcoBoost flogged and analyzed by Ignition

Aside from the way it looks and perhaps its independent rear suspension, the biggest bit of news on the 2015 Mustang may be the inclusion of its 2.3-liter, turbocharged four-cylinder engine. That blown mill marks the first time since the Mustang SVO of the '80s that a turbo has been fitted under the engine of Ford's pony car.
The Mustang EcoBoost is the subject of the latest episode of Ignition from Motor Trend, giving us a great look at the technical, nitty-gritty side of the turbocharged coupe. Covering it from bow to stern, host Carlos Lago walks us through the boosted Ford before taking to the track for some driving impressions, with particular praise given to the low-end grunt of the 2.3-liter mill.
Check out the full video and then let us know which 2015 Mustang has your interest piqued the most - the EcoBoost four, the 5.0L V8 or the entry-level V6.

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.