1982 Ford Bronco 4x4 Bov Not Cucv on 2040-cars

VIN: 1FMDU15E6CLA54496 Year: 1982
Exterior Color: Green
Make: Ford
Interior Color: Black
Model: Bronco
Number of Cylinders: 6
Trim: XL
Drive Type: 4X4
Mileage: 300,000
Warranty: Vehicle does NOT have an existing warranty

Condition: Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ... 

For sale is a nearly completed project bronco that I have worked on for better part of the last two years. Due to a military transfer, I am forced to sell it.

The goal for this truck was to rebuild it to be 100% mechanically reliable and off-road capable. While some body panels were replaced, the rough exterior look was maintained to have a military-vehicle appearance. It was built to be durable using only top quality components. This truck would make a perfect bug-out vehicle, hunting vehicle or off-road toy.

The truck currently starts every time, runs, and is drivable but does require some fine tuning to get the timing and fuel to air ratios correct. The exhaust system does not include a catalytic converter so the vehicle is not road legal. Check your local and state laws. Vehicle originally had 300,000 miles on it when I started this project. I have put on only 250 miles since it's been completely rebuilt. I have a clean title in hand.

Restoration included frame-off, rust treatment and the replacement or reconditioning of virtually every part of the truck. Below is a complete list of modifications and replacement parts.

Engine:
Newly rebuilt 300cc Ford 4.9 inline six (only 250 miles since overhaul)
Engine bored .030 over (this is the original motor)
3-angle valve job
Ground and reworked crank and rods
All new main bearings, cam bearings
All new valves, valve guides
New rockers and springs
Comp cam camshaft (mild cam)
All new gasket kit
New harmonic balancer
New oil pump, water pump
New distributor, new power steering pump
Offenhauser aluminum intake
New flywheel
New Bosch fuel pump and filter
New Edlebrock 500 carburetor
New engine starter
New radiator with new 180 degree thermostat
Glass-pack exhaust - no cat

Chassis:
All new polyurethane body mounts all with new grade-8 hardware
New engine mounts,
New polyurethane transmission mounts with new grade 8 hardware
Frame off restoration included blasting and painting frame

Suspension:
New Energy Suspension front suspension bushings: pivot and radius-arms
All new Bilstein 5100 off-road shocks and struts
2” aftermarket lift coils in front
F250 leaf springs in rear for lift
New grade-8 leaf spring U-bolts
Monroe steering stabilizer
Front end alignment just completed

Drivetrain:
New chrome-moly rear axles
New Borgeson steering shaft
Newly rebuilt T18 4-speed manual transmission with granny gear
All new Timken wheel bearings
New 11 inch(upgraded) Beck/Arnley clutch and new clutch components(fork, linkage components)
New Mile-Marker locking hubs
All new brake components: premium hubs/drums, new pads, new wheel lugs, new stainless steel brake lines, new master cylinder
All new wheel studs
All new greasable Moog tie-rods steering components
New Precision u-joints on driveshaft
Rebuilt Ford 9-inch rear differential w/ 3.50 gears (Timken bearings, new factory limited slip clutches)
31 inch Mud-King tires with approx 85% tread remaining

Electrical:
New 100 amp alternator
New battery
New aftermarket gauges (eng temp, fuel gauge, oil pressure, tachometer, battery volt indicator)
Engo 12000 lb electric winch(new)
New Sylvania Silver Star headlights
Mostly new wiring, new electrical sockets
New Brake light housings
New turn signal housings, All new bulbs

Body:
New floor-pans welded in
New upper rear wheel arch weld patches installed over rear wheel wells
2 brand new fenders
Brand new tailgate
Custom winch bumper (3/8th steel winch box, 1/8th inch steel sides
Custom expanded steel grill
New headlight housings
Raptor bed-liner on rocker trim(black) and rear bumper
Reproduction Vietnam era Marine Corps Forest Green


Interior:
6 way power driver’s seat(not yet wired)
New seats (these were taken out of a Chrysler Concorde)
New dash pad
Custom accessory control panel (lights, wipers, etc)
Cobra CB radio
Center console storage
Second row seat delete
Raptor bedliner floor and interior
Overhead red dome light

Misc:
New 25 gallon Spectra-premium fuel tank and sending unit
New starter solenoid
New ignition control module
New horn
New flasher
New wipers
New wiper motor
All new hoses: cooling, fuel
All new Gates brand belts: power steering, water pump, alternator
All new weather-strips: door seals, window scrapers, etc
All fluids are new, differentials, transmission, transfer case, anti-freeze, engine oil, power steering

Still needs work:
Exhaust system has no catalytic converter
Needs new tailgate motor (currently removed)
Needs new rear driveshaft (CV joint noise)
Engine and carb require fine tuning
Heater motor/selector not currently wired or installed
No AC installed
battery volt indicator not yet wired

Payment will be in the form of PayPal, cash (in person) or certified check. A down payment of $500 is required within 48 hours of auction end with the remainder of the total due within 7 days or the auction will be re-posted. Zero feedback bidders: contact me before bidding or your bids may be removed! Thanks.

Shipping or pickup of the vehicle is solely the buyer's responsibility. I will assist with loading the vehicle on a trailer, but I will not deliver it.

This vehicle is sold AS-IS with no warranty. Winning buyer acknowledges that this vehicle is not currently road legal in it's current configuration and will abide by all local and state laws and regulations.