12 Ford F-250 Superduty 4x4 6.7l Powerstroke Diesel 8" Lift Kit 20" Chrome 37's on 2040-cars

Auto blog

Ford E-Series chassis cabs and cutaways to survive mass Transit onslaught

In March 2013, Ford announced we'd be getting chassis cab and cutaway versions of the Transit. Since incoming Transit vans will soon be rolling over the grave of the E-Series van, it was assumed that all E-Series models would go six feet under as well. According to a report from PickupTrucks.com, however, that's not the case, the report claiming that the highly modifiable E-350 and E-450 chassis cab and cutaway versions will continue being produced in Avon Lake, Ohio "at least until 2020."
Being decades old, the be-cabbed E-Series platform has found its way under an army of heavy-duty shuttle buses, work truck and ambulances. Ford spokeswoman Jessica Enoch verified the production horizon, telling Autoblog that the particular E-Series configuration "are a higher GVWR than the Transit chassis cab and cutaway (available this summer), which is more Class 2 and a new segment for us." So there you have it.

This is what a 3D-printed liquid metal Ford Torino looks like

Artist Ioan Florea has encapsulated a 1971 Ford Torino with 3-D-printed liquid metal transferred onto the car using technology that he developed, and the result is a stunningly shiny, seamless design.
"The surface has the highest coefficient of reflectivity never achieved before," Florea told us in an e-mail, using "nano-materials and nano-pigments that create an internal three-dimensional structure and dictate the polymer how to behave." Sure... We'll leave it to him to make any more 3-D-printed liquid metal-transferred art pieces.
Florea grew up in Romania, and the motivation behind picking the old Ford as his canvas came from his childhood memories of what an American car is - "big and wide and fascinating," he says - and the European name of the car itself, which it shares with an Italian city.

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.