1987 Ford F-250 Hd Low Mileage Original Condition Beauty Almost Showroom New on 2040-cars

Auto blog

NHTSA and Ford investigating steering issues in Crown Vic, Grand Marquis and Marauder

There may be more steering woes for the Ford Crown Victoria. The National Highway Traffic Safety Administration has opened a preliminary evaluation into the Crown Vic and Mercury Grand Marquis from the 2004 to 2007 model years and the Mercury Marauder for the 2004 and 2005 model years because the steering shaft can jam. The issue could potentially affect an estimated 500,000 vehicles.
According to the regulator, there is a possibility that the driver's side heat shield for the exhaust manifold can rust, dislodge, and then wedge into the steering shaft. If this occurs, it leads to a situation where the driver can no longer control the car.
NHTSA has received five complaints of this happening, including one alleged case with an injury. In that situation, the car was driving onto the highway, lost control and rolled over. One occupant was hurt in the accident.

Ford to pay $17.35 million over Escape recall

Ford had a bit of a recall spree around this time last year, with a pair of issues on the then-new 2013 Escape, followed by a recall of 423,000 2001 to 2004 Escapes because they might accelerate of their own accord. Accordingly, Uncle Sam pasted Ford with a $17.35 million fine because it took too long to inform customers, according to a report from Automotive News.
Ford agreed to settle with the National Highway Traffic Safety Administration, accepting the fine but not admitting fault. The recall, which afflicted Escapes with the 3.0-liter V-6 along with 217,000 Mazda Tributes from 2001 to 2006 and 2008, was due to faulty gas pedals that could stay down after a driver removed their foot.
Ford issued a statement regarding the fine, saying, "We take the safety of our customers seriously and continuously evaluate our processes for improvements. While we are confident in our current processes for quickly identifying and addressing potential vehicle issues, Ford agreed to this settlement to avoid a lengthy dispute with the government."

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.