Roush 427 5 Speed Manual Convertible Redfire Metallic Red Stick Not Shelby Gt500 on 2040-cars

Auto blog

Ford recalling 205k Edge and Lincoln MKX units for possible corrosion

After the horrible weather last winter, it's hard to look forward for the season to return this year. For those readers in much of the country, the snow is going to be flying soon, and with it comes salt on the roads. That means Ford's regional recall for the 2007-2008 Edge and Lincoln MKX arrives at the perfect time because they are at risk for corrosion.
The campaign covers 204,448 examples of the models in 21 states, plus the District of Columbia and some provinces of Canada. In total there are 186,024 vehicles in need of repair in the US and 18,424 in Canada.
According to Ford, it's possible for the area, "under the reinforcement brackets where the fuel tank is mounted" to corrode. If this happens, there might be a gas smell in the vehicle or even a fuel leak could develop. In fact, the automaker reports that one fire could be related to the problem but no injuries or accidents are reported.

Ford F-150 EcoBoost in NHTSA probe for acceleration issue

According to Automotive News, the National Highway Traffic Safety Administration is launching a probe into 400,000 Ford F-150 models over possible acceleration problems. According to the article, NHTSA has received 95 reports "alleging incidents of reduced engine power during hard accelerations" on 2011 to 2013 F-150 models equipped with the company's 3.5-liter EcoBoost V6 engine.
Automotive News reports that Ford has issued three technical service bulletins "related to intermittent stumble/misfire on acceleration from highway cruise in humid or damp conditions," according to the government agency's documents. About one third of the 95 reports NHTSA has received cited humid or rainy conditions when these problems allegedly occurred.
These technical service bulletins have allowed dealers to address a "condition related to moisture accumulation in the charge air cooler during extended highway cruising at constant throttle in humid or damp conditions," AN reports, citing NHTSA documents. Furthermore, the TSB outlines details for "reprogramming the powertrain control module with the latest calibration and installing a new CAC and air deflector plate."

Watch these videos of an NHRA racer's bodywork blowing off into a crowd

Just a few months ago, fan safety at racetracks was a hot topic following the last-lap NASCAR Nationwide Series crash at Daytona that sent large pieces of racecars into the grandstands injuring 33 fans. Now, a freak incident at a National Hot Rod Association event resulted in a drag racer's bodywork flying into the crowd at the NHRA Four-Wide Nationals in Charlotte over the weekend. The carbon-fiber body of Robert Hight's Ford Mustang funny car blew off toward the end of a run when his engine exploded, but fortunately, the two fans evaluated after the incident were later released without serious injury.
As you can see in the image above, the body flew high into the air before landing on a walkway in front of the grandstands, a bit of happenstance that likely gave most fans enough time and space to move out of the way. Scroll down to watch a couple of videos showing what happened, including one from a fan's perspective that also reveals what appears to be part of the body's metal bracing landing dangerously close to the crowd.