1963 Ford Falcon Base 2.8l on 2040-cars

Auto blog

70% of pickups could use aluminum by 2025

In the next decade, the auto industry will see an explosion in its use of aluminum to cut weight and increase fuel economy, according to a study from market analysts Ducker Worldwide cited by The Detroit News. We are already seeing the lightweight metal show up extensively in luxury models from Europe, but with the impending launch of aluminum-intensive 2015 Ford F-150 (pictured above), North America is using it even more, as well. The report predicts 70 percent of US pickups to have aluminum bodies by 2025.
It won't just be pickups that see the benefit, though. The average amount of aluminum in US vehicles is forecasted by the study to grow from an average of 350 pounds in 2013 to about 550 pounds by 2025. The most common parts to use it will be hoods, doors and - to some extent - roofs, as well.
The massive increase in pickups' aluminum content hardly seems surprising. The F-150 is predicted to use so much that it might cause a short-term shortage, according to one earlier report. At the same time General Motors is heavily rumored to be negotiating with suppliers for the next generation Chevrolet Silverado and GMC Sierra. Ram is the last holdout of the Big Three, but the study predicts that not to last.

Ring Brothers shows 1965-66 Mustang fastback carbon fiber body

We covered one of Ring Brothers' more extreme SEMA builds yesterday, the De Tomaso Pantera-based ADRNLN, but if that well-executed but over-the-top Italian-American exotic is too much for you, then perhaps this Ring Brothers 1965 Ford Mustang fastback with a carbon-fiber body suits your tastes better.
What the performance-parts manufacturer is showcasing with the Mustang is the carbon-fiber body itself, which is fashioned around the 1965-66 fastback. It can be bought from the company and bonded to the skin and unibody as a do-it-yourself project, or you can take your Mustang to Ring Brothers and have the body installed there. The fenders, doors and quarter panels are two-inches wider than stock, and Ring Brothers offers a custom widebody chassis to those who want the complete package.
The show car looks sharp in person lowered on HRE wheels, and we appreciate the bare front end so we can see the supercharged V8 and front coilover suspension, though the details on those performance upgrades are slim. Also note the custom independent rear suspension setup at the rear.

Ford opens the doors on its Swedish rally skunkworks

It's always amazing to see how different kinds of racecars are made. Formula One racers are often constructed in modern architectural marvels that hint at some of the cutting-edge technology going into the racing. Conversely, rallying is all about sliding around on a varied course as fast as possible, but it often leaves a vehicle caked in mud. So it makes some sense Olsbergs MSE, or simply (OMSE) rally car shop in Nynashamn, Sweden, shows technological sophistication in a more down-to-earth setting. It builds Ford Fiesta ST racers for Global Rallycross there, and this new video gives viewers a tour through the work.
Former rally driver Andreas Eriksson runs OMSE. These days instead of racing, he and the company's 46 employees are building Ford racers from scratch. A ton of work goes into constructing each one, and according to Eriksson, it takes 400 hours to complete each body. At times, things are so busy that some of the technicians live in the shop in apartments that are on premises. There's even a restaurant to keep them fed. Sadly the dyno room is empty during this visit, though.
By the time OMSE is done, a rallycross car might resemble a Fiesta ST on the outside, but as you see in the video, it's a completely different beast underneath. Check out the work it takes to build one of them, and scroll down to read more about it in the official release.