Silver Ford Focus Ses, 48k Miles, 5 Speed, Sync, Sunroof, Remote Start on 2040-cars

Auto blog

Ford board pushing Mulally for decision amidst fears story is drowning out other news

Automakers and their executives rarely like to divulge information regarding future goings on, but the board of directors at Ford sound like they're getting a little antsy about chief executive officer Alan Mulally and his plans for 2014.
According to Reuters, as news of Mulally's possible departure to Microsoft continues to swirl, Ford's board is looking to push the affable executive to make a decision about his future sooner rather than later. Apparently, the board is growing concerned that this will-he/won't-he drama may end up distracting the media from covering Ford's other big news events next year - items like the debut of key all-new products like the Mustang and F-150.
So far, the picture for Mulally's eventual successor remains fuzzy, but it's understood that the leading candidate remains the company's chief operating officer, Mark Fields. Just recently, we heard that Mulally will stay until the end of 2014, but a few months ago, Ford seemed open to the idea of him stepping down earlier than that.

Check out Ford's fully automated self-parking car [w/video]

As automakers continue to find uses for autonomous and semi-autonomous vehicle technology, Ford of Europe has announced that it is developing a self-parking system for future use. More advanced than the Active Park Assist already offered in many Ford products, the new Fully Assisted Parking Aid can take full control of the vehicle and can navigate angled and perpendicular parking spots.
While today's Active Park Assist can only parallel park with the driver controlling the gas, brake and gear selection, Fully Assisted Parking Aid can operate steering, gas, brake and gear selection all while making sure the car is properly parked in the intended space. As with APA, the driver pushes a button to make the car look for a proper spot (at speeds of up to 18 miles per hour), and when an adequate space is located, the operator pushes another button (either inside the car or outside via remote control) for the car to park itself - the button must be pressed throughout the whole parking maneuver. Even though Ford says that the car can effect gear selections on its own, the system must still start from Neutral, and the automaker isn't saying whether the car can put itself into Park when done or put itself in Drive when the operator is ready to go.
Ford is also taking the opportunity to announce its new Obstacle Avoidance technology. This automated system is able to detect objects - including pedestrians - in the road, warn drivers of said objects and, if needed, stop and steer automatically to avoid hitting the obstacle. Both systems are still in the prototype phase, so there is no word as to when we could see either on a production vehicle.

NHTSA closes investigations into Ford Taurus, Hyundai Santa Fe

Ford and Hyundai are out from under the scrutinizing eyes of the National Highway Traffic Safety Administration after the government agency said it was closing investigations against both automakers over vehicle safety concerns.
Ford was being investigated for reported damaged speed control cables on Ford Taurus (shown above) and Mercury Sable models, both built between 2000 and 2003. Vehicles with the company's Duratec engines allegedly failed to allow owners to brake as expected. Owners lodged 100 complaints and were involved in five accidents, according to NHTSA records. The American automaker responded to the reports, and on June 21 of this year, said that it would inspect and repair all affected vehicles, regardless of the mileage.
Hyundai was under investigation for a reported loose fastener on the steering shaft of its 2011 Santa Fe (shown in the gallery below). After NHTSA launched its inquiry, the Korean automaker responded with its own investigation that yielded four affected vehicles. Following the inspection of 680 vehicles at its assembly plant, Hyundai said the issue was due to employee error and that no further defects have been found.