For Sale By:Private Seller
Engine:460/429
Drive Type: Auto
Make: Ford
Mileage: 10
Model: Galaxie
Trim: factory
Number of Doors: 2
Up for auction is a 1961 Ford Galaxie two door sedan. The car is in the resto-mod stage with lots of goodies. I did not drag ALL THE PARTS oout for the pix, example there are 2 buckets, rear bench and front bench. plus a ton of trim
Ford Galaxie for Sale
- Frame off restored galaxie 500 427 dual quad 4 speed(US $64,900.00)
- 1973 ford galaxie 500 country sedan wagon big block 400/260hp v8 black
- 1972 ford galaxie 500 hardtop 4 door with 351w and working factory a/c
- 1961 ford galaxie starliner(US $25,000.00)
- 1963 500 xl texas car very nice(US $15,000.00)
- 1968 ford xl galaxie 500 fastback
Auto Services in Georgia
ZBest Cars ★★★★★
Youmans Chevrolet Co ★★★★★
Wren`s Body Shop ★★★★★
Wholesale Tire & Wheel Co ★★★★★
Walton Tire Co ★★★★★
TJ Custom Muffler & Brake ★★★★★
Auto blog
Ford Shelby GT350 Mustang is a track-day weapon with 500 hp
Mon, 17 Nov 2014
Ford promises more than 500 horsepower and a torque peak above 400 lb-ft.
The wait is finally over. After months of spy shots, rumor and innuendo, Ford has officially pulled the wraps off its new Shelby GT350. Judging by the spec sheet and the promises being made - especially that the Shelby GT350 will be "an all-day track car that's also street legal" - the wait appears to have been worth it.
How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]
Fri, 28 Feb 2014Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.
Ford celebrating 80 years of Aussie utes as it prepares to shutter Oz manufacturing
Wed, 26 Feb 2014Ford is ending Australian production after 90 years in 2016, and with it may go perhaps the most iconic vehicles in its auto market - the ute. Car-based pickup trucks like the Ford Ranchero and Chevrolet El Camino were always more of a curiosity than a true market force here, but in Australia, they have long proven hugely popular.
As the legend goes, Ford invented the niche after a farmer's wife had asked Ford Australia's managing director for a more utilitarian car. Her request was simple: "My husband and I can't afford a car and a truck but we need a car to go to church on Sunday and a truck to take the pigs to market on Monday. Can you help?"
Ford's design team came up with a two-passenger, enclosed, steel coupe body with glass windows and a steel-paneled, wooden-frame load area in the rear. The sides of the bed were blended into the body to make it look more unified, and to keep costs down, the front end and interior were based on the Ford Model 40 five-window coupe. Power came from a V8 with shifting chores handled by a three-speed manual. Within a year, the new vehicle was ready, and production began in 1934. Lead designer Lewis Bandt christened it the coupe-utility.