1956 Ford Thunderbird Convertible With Hardtop / Continental Kit on 2040-cars

Auto blog

Toyota Camry, Honda Civic inventories mounting as US automakers make inroads

Two of the hottest-selling cars in America aren't quite as hot as they used to be. The Toyota Camry and Honda Civic are both seeing dealer supplies increase in the face of renewed competition from the much-improved Detroit Three.
According to a report from The Detroit News, the Camry's dealer inventory is 15 days higher than its seasonal average, while the Civic is 25 days above average. Things aren't expected to get better for Toyota and Honda, as RBC Capital Markets analyst Joseph Spak marked the two Japanese offerings as "at risk for reduced output."
The Detroit Three, meanwhile, are seeing supplies dwindle as demand increases, especially for the Ford Fusion, which has seen an 18-percent increase in 2013 sales, and the Chevrolet Cruze, which was second only to the Camry in June 2013 sales.

Watch these videos of an NHRA racer's bodywork blowing off into a crowd

Just a few months ago, fan safety at racetracks was a hot topic following the last-lap NASCAR Nationwide Series crash at Daytona that sent large pieces of racecars into the grandstands injuring 33 fans. Now, a freak incident at a National Hot Rod Association event resulted in a drag racer's bodywork flying into the crowd at the NHRA Four-Wide Nationals in Charlotte over the weekend. The carbon-fiber body of Robert Hight's Ford Mustang funny car blew off toward the end of a run when his engine exploded, but fortunately, the two fans evaluated after the incident were later released without serious injury.
As you can see in the image above, the body flew high into the air before landing on a walkway in front of the grandstands, a bit of happenstance that likely gave most fans enough time and space to move out of the way. Scroll down to watch a couple of videos showing what happened, including one from a fan's perspective that also reveals what appears to be part of the body's metal bracing landing dangerously close to the crowd.

Ford, GM to collaborate on 9- and 10-speed transmissions

Back in October, there were reports that General Motors and Ford Motor Company were hard at work co-developing new nine- and ten-speed automatic transmissions, and now both automakers have confirmed this joint operation. While there are no specific vehicles mentioned to receive either transmission, a collaborative press release issued by GM and Ford mention that the transmission will be designed for front- and rear-wheel-drive cars, crossovers, trucks and SUVs.
These aren't the first powertrain components developed jointly between these cross-town rivals, either. The six-speed automatic currently used in vehicles like the Ford Edge, Ford Fusion, Chevrolet Cruze and Chevrolet Equinox was engineered in a similar fashion. As is the case with this existing transmission, both automakers will assist in the design, development and testing of the new transmissions, but each will build its own units in its own factories. Scroll down for the official press release.