Find or Sell Used Cars, Trucks, and SUVs in USA

1965 Shelby on 2040-cars

US $22,500.00
Year:1965 Mileage:395 Color: Blue /
 Black
Location:

Beverly Hills, Florida, United States

Beverly Hills, Florida, United States

Send me an email at: marcosmbbonnette@ukaccountant.net .

My Factory Five Daytona Coupe completed in 2003 (titled as 2003) and has less than 500
miles on it. This is not a donor car and everything was brand new or rebuilt to OEM Specs or better on the car. The
paint is Ford Guardsmen Blue (PPG 12832 Guardsman Blue / Ford Code: F) with Wimbelton White Stripes.(PPG 8378
Wimbleton White / Ford Code: M) This car had been registered in the State of Connecticut and has passed it's
demanding registration and safety inspection and possess a CT VIN: CT39159 (The Holy Grail of Documentation). She
currently resides in Kissimmee with a Florida Clear Title. I have receipts for every aspect of the build ,this is
not a "Donor Build" all parts were purchased New! This was a very expensive (approximately $65,000) and well sorted
build. She is ROAD LEGAL and is at home at the Track or Car shows. So with 627hp in a 2400lb body, she demands
respect. (Just for bragging rights,that's a higher Power to weight Ratio than Bugatti Veyron Sport) She is not for
amateur's! You been warned LOL!
Car Specific's:
Factory Five Daytona : #3460 Guardsmen Blue / w-Wimbelton White Stripes
Car has passed Vehicle Inspection in CT and has a CT VIN # 39159 Currently in Florida with Clear Title.
Engine:
U-351 SVO Block , Stroked to 427 cu in by Keith Craft (Build Sheet Available on Request) cost $13,000 on its own!
Rear Main Seal: P/N 17015
Main Studs: P/N 154-5403 ARP
Crankshaft: P/N Eagle 4-352-4000-6200-2100
Pistons: Mahl P/N SBF245125F06
Rings: P/N 4130MS -15
Rods: H-Beam Eagle P/N 2-750-6250-2100-927
Main Bearings: P/N 7049M
Rod Bearings : P/N CB-663H
Wrist Pins: P/N 6457808
Camshaft: P/N Comp. 35-000-9
Lifters: P/N 66215-16
Ford SVO "Zero" Balance Harmonic Balancer P/N M6316-C351 (Weight Removed)
Heads: Victor Junior "Stage 3"
Head Bolt Kit: ARP P/N 1554201
Push Rods: P/N Comp. 7973-16
Stud Girdle: Jomar P/N 1125
Valve Settings: P/N SCP 1018 (Coupe) .022/.024 (stock) .017 / .019 (2008)
Scorpion Aluminum Rockers , with Stud Girdles
Poly Engine Mounts
Dyno'd at 627 max hp @ 6300 rpm at 6000 rpm and max trq 613.9 lbs/ft at 4800 rpm
Intake Torque: 26-28 lbs. ft.
Flywheel Torque= 50 # w / Loctite
Fluid Weight and Capacities: Coolant, / Gas 22-gal Fuel Cell, Wgt=136.4# / Oil 13 qts. 22#
{Per Gallon Wgt.: Oil=7.2# / Water=8.4# / Gasoline=6.2#}
Engine has 30 hrs. run time and is in MINT CONDITION
Oiling System:
3-qt Canton Accusump Item 24 016 (manual activation)
Remote Oil Filter w/stainless braided lines
Oil Cooler w/stainless braided lines
Low PSI / High Volume Mellings HP Oil Pump (55-60 PSIG @ Idle)
Canton Frt. Sump Road Race Pan
Ignition:
MSD 6AL
MSD Small Pro Billet (Setup by Jim Marshall)
Fresh Sears Die Hard (Spec. ?)
Fuel System:
Carb: Bigs Stage #7 750 cfm
Aeromotive MN 13204 Req (return design -Stainless Line AN Fittings)
Aeromotive A1000 Fuel Pump
Aeromotive Fuel Filter
Fuel Safe Cell
All Stainless Fuel Line(AN Fittings)
Edelbrock Intake Manifold
K/N Drop Filter Base w/KN 2" x 14" Filter
Snows Performance Stage 2 Methanol and H2O Injection System
All S/S Braided Hose an AN Fittings
Cooling:
Howe Racing Radiator-Special PN 34327LNF w/Custom made Shroud w/Two 13" Fans
Aluminum Radiator Tubes Connected by Blue Silicone Hose
Edlebrock HP Waterpump: P/N 8843
March Pulley Set
Powermaster 125 amp Alternator
Up to 18:1 Compression Ratio Hi Torque Starter
Transmission:
Gordon Levy Racing Super Duty T-5 w/.80 5th
Lakewood Scatter Shield
Poly Trans Mount
Spec Stage 3 Clutch and Pressure Plate with Hays Zero balance Aluminum Flywheel
Independent Rear with Solid Aluminum Mounts for Diff. comes with 2- Chucks (both just rebuilt) 3:54 / 3:73 one
aluminum, one Cast
Suspension:
Cross weighting within .5% weight distribution left to right and within a half percent frt to rr (see docs)
Frt Setup: -2 Camber / 4-5 Caster / .125 Toe In (2008)
Gordon Levy Spec'd Koni 3012 Double Adjustable Shocks
Coil Overs Eibach P/N: 0250-0800-0800 / 0250-0800-0550 Frt. (Interchangeable with rears)
Eibach P/N: 0250-0800-0900 / 0250-0800-0650 Rear
Vintage Sway Bar: Setting with 0550 fronts= 3rd hole (Stiff)
With 0800 fronts= 2nd hole (soft) (Start setting)
15" Wheels PSE Gt 40 Wheels (8.0" Frts 9.5" Rears) w/Goodyear Racing "Billboards )
Torque Specs for T-Bird IRS = 42-57 ft lbs
Torque Specs Hubs= 250 lbs ft
Wheel Size Coupe=Frt: 4.5" backspacing, 15x7 GT-40 / Rear: 6.125" backspacing, 15x9.5
GT-40 / PSD ENG.
Lug Nut Torque:
1/2"
75-85
Brakes:
Gordon Levy Spec'd Wilwood Front and Rear Disc Brake System for 15 " Wheels (Complete) w/Cockpit mounted Wilwood
Proportioning Valve (PN 260-220)
Willwood
Frt. Rotor .81 Thickness, 10.75" Diameter, 6-Bolts
Rotor P/N: 160-5839 (LH / RH) Solid Straight Vane
Rotor P/N: 160-7097 (RH) SRP Drilled
Rotor P/N: 160-7098 (LH) SRP Drilled
Frt. Caliper P/N: DR-120-6816
Rear Rotor .81 Thickness, 12.0 Diameter
Rotor P/N: (LH / RH) Solid Straight Vane
Rear Caliper P/N: DR120-6806
Pads Race: 7112 Willwood "H" Frt. / Rear
Axle Set P/N: 15H-8219K
Hawk P/N: HD-100.480 Blue 9012 Other Choice: DTC 60 / DTC 70
Porterfield P/N: 7752**.1204 R-4 0r R-4E
Currently Running Porterfield Racing Pads / Spare Wilwoods . along with 2- Spare (New) Willwood Front Rotors
7-Guage Stewart Warner (PN SW-1001) Competition (Minor Gauges are 2-5/8" Tach is 9000 rpm version)
Seating is Drivers Side Kirkey Intermediate Seat , (while passenger ride along) is Fiberglass FFR Wrap around
Harness ; Simpson 5-Point Drivers Side / Simpson 4-Point Passenger Side
Swing out Encroachment bars both Passenger and Drivers Sides
Diagonal Cross Bar in Cage
Steering: Flaming River Power Rack , with Mota Lita wraped Wheel with Quick Release

Auto Services in Florida

Xtreme Car Installation ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Automobile Accessories
Address: 3663 NW 79th St, Virginia-Gardens
Phone: (305) 836-0118

White Ford Company Inc ★★★★★

Auto Repair & Service, New Car Dealers, Automobile Body Repairing & Painting
Address: 916 N Young Blvd, Cedar-Key
Phone: (352) 493-4297

Wheel Innovations & Wheel Repair ★★★★★

Automobile Parts & Supplies, Wheels, Hub Caps
Address: 5920 University Blvd W, Saint-Augustine
Phone: (904) 731-0867

West Orange Automotive ★★★★★

Auto Repair & Service
Address: 917 W Oakland Ave, Hiawassee
Phone: (407) 877-2886

Wally`s Garage ★★★★★

Auto Repair & Service, Auto Oil & Lube, Truck Service & Repair
Address: Buena-Ventura-Lakes
Phone: (352) 357-0576

VIP Car Wash ★★★★★

Auto Repair & Service, Car Wash, Automobile Detailing
Address: 5910 S Military Trl, Cloud-Lake
Phone: (561) 965-6000

Auto blog

EPA says fuel economy test for hybrids is accurate

Mon, 26 Aug 2013


The EPA says it stands behind its fuel economy test for hybrid vehicles following controversy about the testing process after Ford C-Max Hybrid customers and automotive journalists alike struggled to achieve 47 miles per gallon, the advertised mpg number, Automotive News reports. Ford responded to the issue almost two weeks ago by claiming that a 1970s-era EPA general label rule was responsible for the inaccurate mileage numbers, rerating the C-Max Hybrid's mpg numbers and offering customers rebates. Ford later said it didn't overstate the C-Max Hybrid's fuel economy and that it was surprised by the low numbers.
Ford technically didn't do anything wrong because it was following the general label rule, but agency regulator Christopher Grundler says the automaker was exploiting a loophole when it came up with the hybrid C-Max numbers, and that the testing process remains accurate. The general label rule allows vehicles that use the same engine and transmission and are in the same weight class to share fuel economy numbers, but it doesn't take into account other factors such as aerodynamic efficiency, which affects hybrids more drastically than non-hybrid vehicles. Ford originally used the Fusion Hybrid economy figures for the C-Max Hybrid and claimed the engineers didn't realize that its aerodynamic efficiency would affect fuel economy as much as it did.

Submit your questions for Autoblog Podcast #324 LIVE!

Tue, 12 Mar 2013

We're set to record Autoblog Podcast #324 tonight, and our friend Peter Leung (a.k.a. BaronVonClutch), who writes about racing for Richland F1 is going to teach us how to love the vroom-vroom. Drop us your questions and comments regarding the rest of the week's news via our Q&A module below. Subscribe to the Autoblog Podcast in iTunes if you haven't already done so, and if you want to take it all in live, tune in to our UStream (audio only) channel at 10:00 PM Eastern tonight.
Discussion Topics for Autoblog Podcast Episode #324
Geneva Motor Show highlights from Zach

Galpin Ford GTR1 supercar debuts in Monterey

Fri, 16 Aug 2013

Galpin Auto Sports has finally taken the wraps off the car we first previewed back in December, the Galpin Ford GTR1. A few weeks ago, we posted the first hints of just what the GTR1 would be capable of, with Galpin teasing that its 5.4-liter, twin-turbocharged V8 would produce in excess of 1000 horsepower, with a top speed of 225 miles per hour. Package all that in a coachbuilt body, and you have the recipe for one wicked supercar.
The price for the carbon fiber-bodied car is $1,024,000.
Now, we have all the glorious details. Galpin is targeting a production run of six cars, but if interest is strong enough, will expand its initial quote to 24 vehicles. The price for the carbon fiber-bodied car is $1,024,000. Opting for the aluminum bodywork could lower that, although it's not immediately clear by how much.