2011 Honda Civic Si Coupe 2-door 2.0l on 2040-cars

Auto blog

NHTSA gives okay for three automakers to skirt tire-related recalls

BMW, Honda, and Mercedes-Benz are all going to avoid small recalls, after the National Highway Traffic Safety Administration issued petitions for "findings of inconsequential noncompliance" to the three manufacturers, according to Tire Business. Basically, the petitions allow the brands to avoid recalls for some very, very minor issues.
BMW had tire placards on 364 X6 M CUVs that stated the car could only handle four passengers, when in reality it had room for three in the back. Actual plausibility of fitting three real humans in the slope-roofed Bimmer aside, the Munich-based manufacturer argued it was inconsequential, as the placards were correct regardless of the number of passengers.
Honda's case focused on 212 2011 and 2012 Acura TSX sedans equipped with 18-inch wheels. The TPMS systems on these cars were set for 17-inch wheels, rather than the larger hoops, but even with the lower settings, the tires maintain adequate load capacity.

2014 Honda HPD CR-Z

Honda invited us to its Southern California North American headquarters last week to take a spin in a very special CR-Z - one modified with a full complement of Honda Performance Development (HPD) components. While the company has been racing with HPD parts for years, this is the first time the automaker has offered them for its street-legal vehicles, and it has chosen this year's SEMA Show in Las Vegas to be the launch venue. Last year, Honda introduced the HPD Supercharged CR-Z Concept at SEMA - this is the slightly modified production version.
The complete transformation gives the normally placid hybrid hatchback a serious shot of adrenaline thanks to a bolt-on supercharger combined with suspension, tire, brake and exhaust upgrades. In addition to the blower (detailed in a bullet point below), new HPD suspension components lower the car by about half an inch, and firmer spring rates stiffen the ride. Stock 16- or 17-inch wheels are then replaced with HPD 18-inch alloys wrapped in sticky Michelin Pilot Super Sport tires (215/40ZR18 at all corners). The clutch is upgraded, a limited-slip differential is installed and new HPD monobloc four-piston calipers are fitted over slotted and ventilated iron rotors up front (the single-pistons over solid discs on the back axle are unchanged). In the rear, the stock hidden single exhaust pipe is replaced by a free-flow twin-tip exhaust that peers out of a new HPD lower diffuser. Other cosmetic enhancements include an HPD front lip spoiler, rear deck lid spoiler and an HPD emblem kit for each side. To say the CR-Z is transformed by the complete HPD package is an understatement.
Driving Notes

Japanese automakers ramping production for renewed American sales

The 2011 earthquake and tsunami that struck Japan took quite the toll on the automotive industry in that nation. Not content to lean on that tragedy as excuse for slagging sales, the Japanese automakers are planning on a major production expansion in North America. The aim is to reclaim the market share lost from the Tsunami-based dip, and overcome a dollar/yen exchange rate that makes exporting to America unprofitable.
Following the Tsunami, Japanese automakers ramped up production in their North American facilities to compensate, but according to Automotive News, Nissan, Honda and others have all reported plans for still-further increased production in the year ahead. As part of this ramp-up, Mazda will open a facility in Salamnca, Mexico before March of 2014. Part of that increase in output is 50,000 units of a Toyota-badged compact car, which Mazda will produce.
Other Mexican production facilities opening include a Honda plant, which will open in Spring 2014 in Celaya, and a Nissan plant, set to open later this year in Aguascalientes. Nissan also said that it will need another plant in North America within the next five years. According to Nissan Boss Carlos Ghosn, the company aims to raise its stake in the US market from 8 percent to 10, and adding production will help achieve that goal. Even Mitsubishi is aiming to boost production at its Normal, Illinois plant. Production of the Outlander Sport is currently at 50,000, which Mitsubishi wants to raise to 70,000.