2005 Jeep Liberty Limited Sport Utility 4-door 2.8l on 2040-cars

Auto blog

7 months later, Jeep 'trailer hitch' recall still stalled

For the past few years, Chrysler and its CEO, Sergio Marchionne, have gone head-to-head with the National Highway Traffic Safety Administration and its boss, David Strickland, over the government safety agency's request for Chrysler to recall almost three-million Jeep vehicles due to what NHTSA says is a safety issue that has caused at least 51 deaths. After a three-year investigation and Chrysler's initial refusal to issue a recall because it deemed the vehicles safe and built to the day's federal requirements, last summer, the two parties compromised on a "voluntary campaign" to inspect 1.56 million vehicles, those being the 1992 to 1998 Grand Cherokee and 2002 to 2007 Liberty.
Those vehicles were designed with their gas tanks between the rear axle and the bumper, and NHTSA says that in rear-end collisions, damage to the fuel tank has caused fires responsible for those 51 deaths. The compromise reached last summer was that Chrysler would inspect 1.56 million vehicles and, "if necessary, provide an upgrade to the rear structure of the vehicle." Practically speaking, that meant Chrysler would replace aftermarket trailer hitches, but would take no action if a vehicle had a factory-installed hitch or an aftermarket hitch from Mopar.
A report in The Detroit News says the "voluntary campaign" is just now getting under way, with Chrysler saying last week that the design of the replacement part had been finalized and it was tooling up "to deliver the required volume." Seven months later, still in question is whether NHTSA will crash-test the fix engineered by Chrysler, noteworthy because not only did the vehicles in question pass every safety standard necessary to be cleared for sale at the time, there are still questions (to those of us on the outside) as to how the Jeeps at issue fare among their peers in such incidents. Either way, Chrysler and NHTSA apparently still disagree on the efficacy of the remedy itself: the carmaker says it might help in low-speed crashes but not high-speed collisions, a position the NHTSA is at odds with. All of this means the campaign doesn't yet have an end in sight.

Chrysler 3.0L EcoDiesel V6: Autoblog Technology of the Year finalist

Offering a diesel engine in an American pickup is anything but new - Ford, General Motors and Chrysler all offer excellent and almost impossibly powerful oil-burning engines in their various fullsize trucks. What is new and novel about the 3.0L EcoDiesel, though, is its size, and the variety of vehicles that use it. It's the smallest engine, as far as displacement is concerned, currently offered in a large truck in the US, and, for 2014 and 2015, it is available in the Ram 1500 and the Jeep Grand Cherokee.
Though it may be small, it's got muscle. While 240 horsepower isn't particularly impressive these days, the engine's 420 pound-feet of torque more than makes up for that. The torque rating is even greater force than even the big 5.7-liter Hemi can muster. Chrysler's well-regarded eight-speed automatic transmission makes the most of all that bull-headed pulling power in both the Ram and Grand Cherokee. Chrysler claims the Ram EcoDiesel 1500 can tow as much as 9,200 pounds when properly equipped, which makes it "90-percent of the Hemi with a night and day difference in fuel economy."
Make no mistake; it's that promise of a sizable fuel economy improvement that many long-haul truckers will be most interested in. In the Ram 1500 that we tested for our Tech of the Year competition, the diesel engine costs $2,850 more than the gas-fed V8, and Ram estimates that EcoDiesel buyers will pay off their investment when compared to the Hemi engine in less than three years, which is considerably less time than the 4.5 or so years the average buyer will keep his or her fullsize pickup. The more you drive, the more you'll save, and the math proves equally as effective in the Jeep Grand Cherokee.

Chrysler axes old V6s, goes all-Pentastar

Old technology has a way of lingering on, particularly at Chrysler headquarters in Auburn Hills. So while the Pentastar V6 has replaced the older engine architecture in just about every application, it still soldiered on in some export markets. But the introduction of a new 3.0-liter Pentastar V6, produced in Michigan and meant only for the Chinese market, has put the final nail in the old engine's coffin.
Fitted into the 2014 Jeep Grand Cherokee and Jeep Wrangler just introduced to China at the Chengdu Motor Show, the downsized six uses the same architecture as the larger 3.6-liter Pentastar V6. But because of its 2,997cc capacity, it can be exported to China without the increased duty the 3.6-liter or even 3.2-liter Pentastar engines would incur. The 3.0-liter V6 develops 230 horsepower at 6,350 rpm and 210 pound-feet at 4,400 rpm.
Admittedly, it's unlikely, but even though the engine was said to be created solely to undercut tax thresholds in China and Europe, the 3.0-liter Pentastar has recently surfaced in rumors of an application here: as the boosted heart of a potential Cherokee SRT with anywhere from 375 to 410 hp.