1966 Dodge Monaco Base 6.3l on 2040-cars
San Fernando, California, United States
|
1966 Dodge Monaco Sedan - Newly Rebuilt Engine and Transmission Up for auction is a 1966 Dodge Monaco sedan. It has a 383 V-8 with an A727 Torqueflite transmission. Each area of the car is described in detail below. Please look at the pictures: if you need pictures of something specific, please ask. Engine The engine was professionally rebuilt by Eddings Engine in San Fernando at a cost of more than $2000, and has less than 30 miles on it. The engine was bored .30 over with new pistons, rings, bearings, camshaft, timing set, and expansion/core plugs. The heads were also professionally rebuilt by Sylmar Head Exchange with new valves, valve guides, springs, and seals. Once I got the heads and engine back, I put in all new parts: new lifters, pushrods, rocker arm shaft, and rocker arms, oil pump, and oil pump drive. Everything but the heads was painted in Chrysler Turquoise. The intake manifold, timing chain cover, oil pan, and valve covers were cleaned and painted. All new Fel Pro gaskets and seals were used on everything. The alternator, water pump, and fan clutch are new. The starter is new. The power steering pump is original, but works well. All belts and hoses are new. The radiator was professionally cleaned and painted by The Radiator Works in Northridge. Most of the bolts used to attach various parts to the engine (water pump housing, intake manifold, etc.) are new reproduction. I installed a correct set of reproduction plug wire routing brackets. The motor mounts are new. Of course, all fluids are new. The distributor, cap, plugs, and plug wires are new. I converted the points to a Pertronix Ignitor II with a Flamethrower coil. The engine starts right up and runs well, with no leaks, smoke, odd noises, or any other problems. Fuel The 2-barrel Stromberg WWC carburetor was professionally rebuilt by Carbs Only in Burbank. The fuel pump is new. I replaced all rubber sections of the fuel line from the fuel pump back to the tank. The tank was professionally cleaned and painted by The Radiator Works in Burbank. I installed a new sending unit, lock ring, and gasket. There is a new gas cap and a new "donut" seal between the filler pipe and the tank. The tank straps are in good shape. There are no fuel leaks. Transmission/Drivetrain The transmission was professionally rebuilt by Victor Transmission in San Fernando at a cost of about $900. The transmission cooler lines are new. The universal joints, at both the transmission and differential end, are new. The rear differential has not been touched: it doesn't make any noises, but it does have a small drip from the flange seal after the car is driven. The transmission pan has a small leak from the pan gasket: the rebuilder used a cork gasket, and it should probably be replaced by a rubber gasket with sealer. It's annoying, but an easy fix. The transmission shifts very well and does not "bang" into gear. Suspension/Brakes All front brake parts are new. I converted the front drums to front discs using the kit from Scarebird. All new rotors, pads, calipers, hoses, and other parts were used. I had to convert the wheels to 15", so I bought new 15" wheels and Cooper 15" white-stripe tires. The tires have less than 30 miles on them. I also had to replace the original 14" hubcaps with some 15" hubcaps: they are from a '67 or '68 Polara, but are in fantastic shape and look good. The original hubcaps will come with the car. The rear brakes are all new except for the drums (which are hard to find). The drums were in good shape so they were just cleaned up. I also installed a new master cylinder and power booster, and installed new brake lines where necessary. The brakes stop very well. The front suspension is mostly new: all control arm bushings, shocks, sway bar bushings, strut bushings, ball joints, tie rods, rubber bumpers, and idler arm. The Pitman arm and steering box have not been touched, but the car steers well. It will need a front-end alignment. The rear springs, bushings, and hangers are new: I replaced the sagging original 5-leaf springs with new 7-leaf springs. The rear shocks are new. Interior/Electrical There are some bulbs in the taillight and turn signals that need to be replaced, but the brake light and turn signals work. All gauges work. The radio works after it warms up: this car has the two-speaker AM radio, with a knob you use to balance sound between the front and rear speaker. Some interior lights work, some do not: I think some of the bulbs are burned out. It probably needs a new headlight switch. The headlight switch turns the headlights on and off fine, but its dimmer function doesn't work. I lubed the speedometer cable, and it doesn't make any noise, but the speedometer needle sways a little at speed. The car was originally equipped with AC, but before I got the car, someone had taken most of the AC components. I have the compressor and some other parts, and they will come with the car. The blower motor doesn't work. All windows go up and down fine, and the vent windows work. All locks work fine. The doors open and close well, except for the driver's door, which has to be slammed to close properly. The front and rear seats will need to be reupholstered. The carpet is OK, but should be replaced. The door panels are OK, but should be refurbished. I took the rear door panels off to do some lubrication, but they will come with the car. The dash pad is cracked and faded and should be replaced. The steering wheel has some cracking and should be refurbished, but the horn works great. The headliner is perfect. The weatherstripping throughout the car needs to be replaced. Body The car was repainted at some point by a previous owner: it was a cheap job, but it seems to have prevented rust. The car has no rust through at all. The floor pan, trunk pan, and underbody are rust free. There is surface rust on the driver's-side rear door, and some small areas of surface rust on other parts of the body, but absolutely no rot. This car has been in California its whole life, as shown by the original Certicard in the engine compartment. There bumpers are in OK shape: they could be polished, but should probably be re-chromed. The chrome trim is in good shape: the only exception is the front part of the driver's-side trim, which is missing because of a small dent in the front fender. There are dents in the rear left quarter panel and one of the front fenders. There are also dents in the right-side rocker panel. Other than that, the body is good and straight. The glass is free of cracks and in good shape. I will include some trim and lenses for the rear taillights, which are a one-year design and very hard to find parts for. I've described the car as honestly as I can, but if you have any questions, feel free to ask. |
Dodge Lancer for Sale
1955 dodge custom royal lancer hemi. southern california car!
2000 ford mustang gt 4.6l convertibale(US $6,000.00)
1988 dodge ramcharger royal se sport utility 2 door, 5.9 litre street truck.(US $9,500.00)
1951 dodge wayfarer 2 dr sedan(US $5,995.00)
2004 dodge ram 2500 4x4 slt 5.9l cummins, automatic, b&w hitch, toolbox,
2006 dodge ram 1500 st crew cab pickup 4-door 5.7l(US $15,000.00)
Auto Services in California
Yuba City Toyota Lincoln-Mercury ★★★★★
World Auto Body Inc ★★★★★
Wilson Way Glass ★★★★★
Willie`s Tires & Alignment ★★★★★
Wholesale Import Parts ★★★★★
Wheel Works ★★★★★
Auto blog
Dodge Charger SRT Hellcat in the works
Fri, 25 Jul 2014In Autoblog's recent First Drive of the 2015 Challenger SRT with the 707-horsepower Hellcat V8 we found its engine to be as brutally powerful as the numbers would suggest, even if it wasn't the best handler. However, the muscle-car-styling just isn't right for some buyers that need four doors and proper rear seats to haul around the family. It appears that Dodge has their backs, though, because the Hellcat is very likely on its way into the Charger in the near future. Imagine the looks on your passengers' faces when you stomp down on the throttle.
According to Road and Track, when Dodge submitted the Hellcat for engine power certification to the Society of Automotive Engineers, the company included the Charger on the paperwork. That showed that the automaker wanted the engine checked out for the sedan, too. R&T reckons the 707-hp Charger would hit the road about a year from now, clearing the Challenger for a year of exclusivity with the powerplant.
When the Charger SRT Hellcat does hit the road, it may carry a very special accolade. Assuming nothing beats it in the meantime, it might be the world's highest horsepower production sedan. Think on that for a second. Even a Mercedes S65 AMG only has 621 horsepower, though a good bit more torque at 738 pound-feet to the Dodge's 650 lb-ft. So while the beastly engine is getting put into other models, where else would you like to see it? The Ram? Grand Cherokee? Let us know in Comments.
Are you the Dodge Dart SRT4?
Tue, 08 Jan 2013Dodge has just confirmed that it will be bringing its newest Dart variant, the Dart GT, to Detroit next week, but we're still in the dark about when we'll see a truly hotted-up SRT4 version. But now, by way of the rumormill anyway, we've got at least one proposed, potentially Dodge-based rendering to light our way.
Seen here is what would appear to be a design sketch of the SRT4 Dart. Obviously the image that has surfaced is of rather low-resolution, but there's at least some evidence to support that it may be legitimate. In the original picture, one can just make out the name Tim Doyle in the lower right corner. As it turns out, Tim Doyle's name is also watermarked on the final design image for the 2011 Dodge Durango Citadel Black & Tan, a model that was shown at SEMA in 2010.
Of course, even if this really is the work of Doyle, there's nothing to say that this image isn't one of a great many potential looks for the future SRT4. In fact, the departure of the cross-hair grille from the Dodge's nose seems like it could be a hard sell, though we do, naturally, dig the sleek hood scoop and the bulked up wheel/tire combination.
Dodge celebrates centennial with Charger and Challenger 100th Anniversary Editions
Tue, 19 Nov 2013In 1914, the Dodge brothers went from being a parts supplier to a full-scale automaker, and to celebrate the centennial of this milestone, Dodge will offer special editions of the 2014 Charger and Challenger early next year. Both cars will be sold in limited numbers (although no specific number was given), and these cars will stand out thanks to unique touches like 20-inch wheels, 100th anniversary edition logos and the exclusive High Octane Red Pearl Coat paint job (shown above).
The 100th Anniversary Edition package, which runs $2,200 on the 2014 Charger and $2,500 on the 2014 Challenger, comes with red or black leather seats with a cloud print (for a denim-like look) and metal badges on the seatbacks that read "Dodge Est. 1914," while similar logos are also found on the wheel center caps and front fenders. The instrument gauges are unique to each car, with the Charger getting black gauges and the Challenger getting white gauges, and to enunciate the 100-year anniversary, both cars have red numerals on the speedometer for the 100-mile-per-hour mark.
Finishing off the 100th Anniversary Edition cars, which will be offered on V6 and R/T models, Dodge adds a flat-bottom steering wheel and embroidered floor mats as a part of the package. Scroll down for the full press release for these commemorative models.