1991 Dodge Stealth Es Hatchback 2-door 3.0l on 2040-cars

Auto blog

2015 Dodge Challenger SRT Hellcat with '600-plus horsepower' officially unveiled [w/video]

Dodge has officially unveiled the most powerful vehicle to ever wear the Challenger name - the SRT Hellcat - complete with over 600 horsepower courtesy of a supercharged, 6.2-liter Hemi V8. It will be offered alongside the 485-hp Challenger SRT.
The new, force-induced V8 isn't just the most powerful ever fitted to the Challenger, it's the most powerful eight-cylinder Chrysler Group has ever built. Power figures aren't finalized, so expect to see "over 600 hp" bandied about quite a lot. That fury will be channeled through either a six-speed manual or eight-speed automatic. Yes, over 600 ponies through an eight-speed auto. So far, the only vehicle we know of that delivers more output through that many gears is the as-yet untested Chevrolet Corvette Z06. Sadly, we don't have performance metrics just yet, although if this thing can't crack four seconds to 60 miles per hour, we'll be pretty surprised.
As is the theme nowadays, the 2015 Challenger SRT features a number of driving modes, governing power output, shift speeds for the 8AT, steering effort, traction control settings and suspension settings. There are three pre-programmed options - Default, Sport and Track - and a Custom mode that allows drivers to mix and match to their heart's content.

NHTSA investigating power modules on Chrysler Group SUVs and minivans

The Center for Auto Safety is officially petitioning the National Highway Traffic Safety Administration to begin scrutinizing alleged problems with the totally integrated power module (TIPM) on about 24 Chrysler Group SUVs and minivans. The advocacy group claims that the part's failure can cause affected vehicles to stall or not start at all. NHTSA is still looking into the accusations and deciding whether a full investigation is actually warranted.
The CAS petition claims at least 70 TIPM failures, but according to NHTSA, six of the complaints are for models that don't have the modules. In 34 of the reported cases, the vehicles refused to start, and in 17 of them the engine stalled. There were also two allegations of smoke and one of a fire. However, none of these affected airbag deployment or resulted in a crash.
This petition isn't the first TIPM-related problem for Chrysler Group. A recent report in the New York Times alleged that it found 240 complaints potentially related to the issue on NHTSA's website alone. In September, the automaker also recalled 230,760 examples worldwide (188,723 in the US) of the 2011 Jeep Grand Cherokee and Dodge Durango replace the fuel pump relay circuit inside of the TIPM-7 with one external to the unit. The original part could allegedly cause the models to stall without warning. Even earlier, the company also recalled about 80,000 examples of the Jeep Wrangler and Dodge Nitro in 2007 to have the module reprogrammed.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.