1925 Ford Model Tt Hot Rod on 2040-cars

Auto blog

Ford brings FPV Falcon production in house [w/video]

For the first time since 1976, Ford of Australia is bringing the assembly of its stonking Ford Performance Vehicle line back in-house to the company's Broadmeadows and Geelong facilities. That's a point of pride for FPV, which builds high-performance versions of the Australian Falcon model like the F6, GS and the heroic GT seen here.
In the video below, we hear FPV employees talking in hushed tones about the important legacy that cars like the GT have for Australian gearheads of all stripes, and how proud they are to say that hand-built machines like this GT R-Spec with its Boss 355 engine are now rolling out of their home base. For our part, we're just dying to drive this version of the Coyote V8; the engine is rocking a "Miami" supercharger from Harrop and makes some 450 horsepower.
Continue on below for the video, or you can check out some images of the new FPV at the facility, as well as a gallery of the GT R-Spec car.

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

Ford Mustang GT350 drops some camo

Now that we've poured over the 2015 Ford Mustang in its standard form, it's time to look ahead. We already knew (and heard - literally) that Ford was working on a higher-performance version of its 'Stang to replace the Shelby GT500, and earlier reports have stated that it will simply be called the GT350.
We don't have a ton of detail to go on, but this latest set of spy photos clearly shows a hood-mounted air scoop, which suggests a forced-induction powerplant is under the hood. However, this disagrees with earlier reports that the GT350 will be all motor, using a naturally aspirated engine to send massive horsepower to the rear wheels. Our spies also point out the functional vent aft of the front wheels to allow for better airflow, and the massive quad exhaust pipes can be seen, clear as day.
Expect to see the Mustang GT350 in April, when it debuts at the New York Auto Show in conjunction with the Pony's 50th anniversary. In the meantime, have a look at our gallery above to see the latest shots of the hot Mustang out testing.