Ford F-250 Fx4 on 2040-cars

Auto blog

Watch these Australian Ford and Holden muscle cars duke it out

Australia's Motoring has put together a little video on two of the great performance vehicles available down under - the Holden VF Commodore HSV GTS and the Ford Falcon FPV GT R-Spec. And while both FPV and the Falcon might be on their way out, there's still plenty of time for a little head-to-head comparison between the two.
The cars aren't all that well evenly matched, though. The Ford boasts a 5.0-liter, supercharged V8, which the Aussies measure out at 449 horsepower and 420 pound-feet of torque. The HSV, though, with its Corvette-derived, 6.2-liter, supercharged V8 is just too powerful - 576 hp and 545 lb-ft of torque.
Predictably, it doesn't end too well for the Ford. As the guys from Motoring point out, the new VF Commodore is just too new and too good, with its extra power and its adaptive dampers (GM's excellent MagnaRide). Interestingly, Motoring did point out that the Holden's electric steering is better than the Ford's hydraulic steering, which is a lot like a Porsche purist saying they prefer water-cooled engines to air cooled.

Ford opens the doors on its Swedish rally skunkworks

It's always amazing to see how different kinds of racecars are made. Formula One racers are often constructed in modern architectural marvels that hint at some of the cutting-edge technology going into the racing. Conversely, rallying is all about sliding around on a varied course as fast as possible, but it often leaves a vehicle caked in mud. So it makes some sense Olsbergs MSE, or simply (OMSE) rally car shop in Nynashamn, Sweden, shows technological sophistication in a more down-to-earth setting. It builds Ford Fiesta ST racers for Global Rallycross there, and this new video gives viewers a tour through the work.
Former rally driver Andreas Eriksson runs OMSE. These days instead of racing, he and the company's 46 employees are building Ford racers from scratch. A ton of work goes into constructing each one, and according to Eriksson, it takes 400 hours to complete each body. At times, things are so busy that some of the technicians live in the shop in apartments that are on premises. There's even a restaurant to keep them fed. Sadly the dyno room is empty during this visit, though.
By the time OMSE is done, a rallycross car might resemble a Fiesta ST on the outside, but as you see in the video, it's a completely different beast underneath. Check out the work it takes to build one of them, and scroll down to read more about it in the official release.

Ford issues six recalls covering 101,000 vehicles for multiple issues

Ford is announcing six separate recalls for a variety of issues affecting a dozen models and a total of 100,610 vehicles in North America. However, according to Ford spokesperson Kelli Felker, "None of them have caused accidents or injuries." Half of them cover fewer than 1,000 cars.
The largest recall covers 92,022 North American examples (about 83,250 in the US) of some models of the Ford Taurus, Lincoln MKS, Ford Interceptor, Flex and Lincoln MKT from the 2013 and 2014 model years; the 2012-2014 Edge and the 2014 Lincoln MKX. All of them have a potential issue with the halfshaft on the right side that might not be fully seated and could move outward over time. If it shifts too far, the models may no longer be able to drive, and the condition could also allow the vehicles to roll away, even when in Park. Dealers will inspect the shaft to make sure it's seated and will replace the part if necessary.
The next-largest recall covers 5,264 North American examples (4,867 in the US) of the Ford F59 Commercial Stripped Chassis from the 2011-2014 model years. It's possible that an electrical junction box can corrode in areas with salty roads and short circuit. The problem could potentially cause a fire. Dealers will replace the box with an improved design.