Auto blog

Volkswagen Cross Up! aimed at rugged lifestyle folks, complete with plastic cladding

If you thought there was nothing wrong with the Volkswagen Up! that a little body cladding wouldn't fix, you're in luck. VW has officially pulled the wraps off the production version of the Cross Up!, and its wheel arches and rocker panels are full of the black plastic cladding you've been yearning for.
In addition to the "particularly rugged design and tough, lifestyle qualities" that the cladding exudes, VeeDub has also seen fit to put its Cross Up! on a new set of 16-inch alloy wheels clad in 185/50-series tires. Inside, there are new kick plates to go along with a dash pad that can be had in red, black or silver.
All that cladding must equal additional off-road readiness, right? Well, sure... just so long as you're fine with the same 75-horsepower three-cylinder engine that all other Up! models also feature, along with a five-speed manual transmission sending power to the front wheels, again, just like all other Up! models. The Cross Up! appears to have a taller ride height than other models, but we haven't been able to find out what - if any - changes have been made.

An inside look at VW's new California R&D center

Less than two months ago, the Volkswagen Group opened a new facility in Oxnard, California (about an hour's drive west of Los Angeles). The $27 million investment, touted as Test Center California (TCC), serves as a research and development lab testing emissions for all brands under Volkswagen's umbrella, including its newest member, Porsche. While still not fully operational, we toured the new 64,000-square-foot building last week and had a first-hand opportunity to see just how much work is involved testing engines and meeting increasingly stringent government emissions standards.
Replacing a similar facility established in 1990 in Westlake Village (about 20-minutes east of the new location), our guide explained how Oxnard was chosen for its temperate climate, varied regional terrain for test drives and low altitude. (The area is only a few feet above sea level - a critical parameter when instrument testing emissions.) The new facility is capable of analyzing hundreds of vehicles, prototypes and customer-owned vehicles, annually.
Most interesting to us was the huge stainless steel climate chamber, with a massive four-wheel dynamometer that allows VW to test running vehicles in both scorching desert and freezing climates without ever leaving the building (an Audi Q7 was running in place during our visit). We were also mesmerized by the countless storage tanks and intricate plumbing of chemicals, stored in both liquid and gas states, needed to perform the variety of tests. Lastly, we took a look at Bugatti's service center on the west coast, located completely within the new center. While there were no supercars on site, the facility is equipped with plenty of spare forged wheels (mounted with expensive Michelin PAX tires) and a Veyron-specific repair jig that allows the vehicle to be completely disassembled, if needed. It is a shame that the facility, which set off all of our automotive geek alerts, is closed to the public.

North American production of foreign marques to jump in 2014

Wards Auto has released its North American Light Vehicle Production Forecast for 2014, and the report predicts foreign manufacturers will increase production on the continent some 3.9 percent by 2014. If accurate, that should see 123,000 additional cars, trucks and vans produced in North America, swelling the total number of units produced both by domestic and foreign manufacturers to 16.9 million light vehicles from a projected 15.6 million in 2013. Much of the increase can be attributed to the fact that Toyota intends to produce another car at its Blue Springs, MS plant as well as a new Lexus model at its Georgetown, KY facility in a year's time.
Likewise, Volkswagen intends to move production of a currently imported model to its plant in Puebla, Mexico. Daimler, Honda, Nissan and Mazda also plan to build additional models on North American soil for the first time. Around two-thirds of the new North American manufacturing will take place in Mexico, helping the country soak up a full 20 percent of the content's automotive production for the first time. You can head over to the Wards Auto site for the full report.